Ετικέτες

Δευτέρα 30 Ιανουαρίου 2017

Effect of Ni addition on the wettability and microstructure of Sn2.5Ag0.7Cu0.1RE solder alloy

Publication date: 5 April 2017
Source:Materials & Design, Volume 119
Author(s): Yaoli Wang, Guangxin Wang, Kexing Song, Keke Zhang
In order to study the effect of Ni addition on the wettability and microstructure of Sn2.5Ag0.7Cu0.1RE solder alloy, samples of 7compositions were prepared with Ni content ranging from 0 to 0.5% and contents of other alloying elements (Ag, Cu and RE) being kept the same. Results obtained have shown that the wettability of Sn2.5Ag0.7Cu0.1RE can be largely improved by adding 0.1% Ni in the alloy, and Sn2.5Ag0.7Cu0.1RE0.1Ni exhibits a better wettability than the commercially used Sn3.8Ag0.7Cu alloy. The wetting angle measured on Cu substrate is clearly larger than that measured on Cu wire, which is considering the "static" and "dynamic" natures of the two testing procedures. In addition, Ni has been found to be able to reduce the volume fraction of primary Sn, increase the ratio of eutectic structure and form a much finer eutectic microstructure from a three-dimensional view of the microstructure after deep-etching. Moreover, Ni shows a clear impact on the interface between Cu substrate and solder alloy. Compared to the solder alloy without Ni, adding 0.1% Ni leads to a relative flatter and thinner interface. For the solder alloy with 0.5% Ni, micro-cracks are observed at the interface.

Graphical abstract

image


http://ift.tt/2jOaLqt

Δεν υπάρχουν σχόλια:

Δημοσίευση σχολίου

Αναζήτηση αυτού του ιστολογίου