Ετικέτες

Σάββατο 21 Απριλίου 2018

Wettability of AlSi7Mg alloy on alumina, spinel, mullite and rutile and its influence on the aluminum melt filtration efficiency

Publication date: 15 July 2018
Source:Materials & Design, Volume 150
Author(s): Claudia Voigt, Lisa Ditscherlein, Eric Werzner, Tilo Zienert, Rafal Nowak, Urs Peuker, Natalia Sobczak, Christos G. Aneziris
Despite the application of aluminum melt filtration with ceramic foam filters since the 1960s the process is not fully understood. Outstanding issues are for example the influence of the wetting behavior and filter chemistry on the filtration efficiencies.Contact angle measurements by the sessile drop method coupled with non-contact heating and capillary purification technique were conducted at 730 °C with AlSi7Mg alloy on the substrates of four different oxides (Al2O3, MgAl2O4, 3Al2O3·2SiO2 and TiO2). The highest contact angle was measured on 3Al2O3·2SiO2, followed by MgAl2O4, Al2O3 and TiO2.Experimental values of contact angles were correlated with the evaluated filtration efficiencies of filtration trials performed at Constellium. They show a good correlation for inclusions smaller than 110 μm - the larger the contact angle the higher is the filtration efficiency.The adhesion forces of alumina inclusions on the four filter materials were experimentally estimated with an AFM in water based model system. The highest adhesion forces were measured on the Al2O3 substrate, followed by the 3Al2O3·2SiO2, the MgAl2O4 and the TiO2 substrate. For inclusions >70 μm, both the measured filtration efficiencies for >70 μm and the adhesion forces increase by the following order of coatings: TiO2, 3Al2O3·2SiO2, MgAl2O4, Al2O3.

Graphical abstract

image


https://ift.tt/2Jg3JET

Δεν υπάρχουν σχόλια:

Δημοσίευση σχολίου

Αναζήτηση αυτού του ιστολογίου