Ετικέτες

Σάββατο 30 Σεπτεμβρίου 2017

ChromiSense: A colourimetric lab-on-a-disc sensor for chromium speciation in water

Publication date: 1 February 2018
Source:Talanta, Volume 178
Author(s): G. Duffy, I. Maguire, Brendan Heery, Pauline Gers, J. Ducrée, F. Regan
The development of a centrifugal device for quantitative analysis of both chromium (III) and (VI) species in water is reported. ChromiSense is a colourimetric sensor system that has been applied to the measurement of chromium in spiked river water samples. For analysis, the sample is loaded into a reservoir on the disposable microfluidic disc, along with reagents. A centrifugal force is created by spinning the disc to pump liquids through microchannels, causing them to mix and react to form a coloured product. The coloured product is then presented to a low-cost optical detection system, where absorbance measurements can be recorded. The optical detection system consists of a light emitting diode (LED) and photodiode (PD) couple. Chromium (III) was measured using 2,6-pyridine dicarboxylic acid as a ligand, forming a complex that was measured at 535nm and at 335nm. While measuring at 535nm allowed for the use of a low cost LED, the sensitivity was improved 2.5 times by measuring at 335nm. However, 335nm also yielded a diminished linear range with little improvement in limit of deteciton (LOD), and required a lengthier manufacturing process due to the need for a UV-transparent material. Chromium (VI) was detected using 1,5-diphenyl carbazide (DPC). This standard analysis method was simplified for automation on-disc, and optimised to achieve a low LOD. The LOD for trivalent and hexavalent chromium using this device were 21mgL−1 and 4μgL−1, respectively. The linear range for quantitative analysis was found to be 69–1000mgL−1 for Cr(III) and 14–1000μgL−1 for Cr (VI). While this range is high for Cr(III), incorporation of an off-disc pre-concentration method would make this technology suitable for environmental sample analysis. The device is simple to use, low in cost, and could provide rapid on-site measurements, with results comparable to those obtained using a benchtop spectrophotometer.

Graphical abstract

image


http://ift.tt/2yPu0oT

Δεν υπάρχουν σχόλια:

Δημοσίευση σχολίου

Αναζήτηση αυτού του ιστολογίου