Flexural strength, fracture toughness and translucency of cubic/tetragonal zirconia materials

Publication date: Available online 25 May 2018
Source:The Journal of Prosthetic Dentistry
Author(s): Parissa Nassary Zadeh, Nina Lümkemann, Beatrice Sener, Marlis Eichberger, Bogna Stawarczyk
Statement of problemThe development of zirconia materials with optimized properties has been rapid, and studies comparing the mechanical and optical properties of recently introduced zirconia with lithium disilicate materials are limited.PurposeThe purpose of this in vitro study was to compare the mechanical and optical properties of cubic/tetragonal zirconia materials with those of a lithium disilicate ceramic.Material and methodsSpecimens were fabricated from 6 different noncolored zirconia materials: Ceramill Zolid FX (CZ), CopraSmile (CS), DD cubeX² (DD), NOVAZIR MaxT (NZ), priti multidisc ZrO₂ (PD), and StarCeram Z-Smile (SC), and 1 lithium disilicate ceramic as a control, IPS e.max Press LT A2 (CG). Four-point flexural strength (N=105/n=15) and fracture toughness using the single-edge V-notched beam (N=105/n=15) were examined according to International Organization for Standardization standard 6872:2015. Translucency (N=70/n=10) was evaluated with an ultraviolet spectrophotometer. Grain size (N=6/n=1) of zirconia was investigated by using scanning electron microscopy. Data were analyzed using the Kolmogorov-Smirnov test, multivariate analysis, 1-way analysis of variance, followed by the post hoc Scheffé test and Kruskal-Wallis and Mann-Whitney U tests, and Weibull analysis, using the maximum likelihood estimation method at 95% confidence level (α=.05).ResultsZirconia materials showed higher mechanical and lower optical properties than CG (P<.001). No differences were observed among the zirconia materials with respect to flexural strength (P=.259) or fracture toughness (P=.408). CG and CS showed significantly higher Weibull modulus than SC and PD. The lowest translucency values were measured for NZ and SC, followed by CS, DD, and PD (P<.001). CZ showed the highest translucency values (P<.001). The lowest grain sizes were found for NZ, DD, and SC; the largest were shown for CS (P<.001).ConclusionsCubic/tetragonal zirconia showed better mechanical properties than lithium disilicate ceramic. However, the optical properties and the reliability of zirconia are lower than those of lithium disilicate ceramic.



https://ift.tt/2IQymAY