Source:Dental Materials
Author(s): Zhou Xu, Ping Yu, Dwayne D. Arola, Jie Min, Shanshan Gao
ObjectiveTo investigate the wear mechanisms of a polymer infiltrated ceramic network (PICN) material, to compare its wear behavior with that of tooth enamel, and to provide evidence relevant to its clinical use.MethodsThe Vickers hardness (HV) and elastic modulus (E) of a commercial PICN material (ENAMIC) and enamel were measured. Reciprocating wear tests were performed under a ball-on-flat configuration. Three wear pairs were explored including ENAMIC and enamel subjected to Si3N4 ball antagonists and ENAMIC subjected to enamel cusp antagonists. The coefficients of Friction (CoFs) were monitored continuously to 5×104 cycles. The wear depth of ENAMIC, enamel specimens and enamel cusps were quantified using white light interferometry, and the wear morphologies were examined using scanning electron microscopy (SEM) to distinguish the wear mechanisms.ResultsThe HV of ENAMIC is similar to tooth enamel but the E is much lower. For both materials, the CoFs increased sharply in the early stage and then reached plateaus in the later phase. Throughout the cyclic loading history, ENAMIC exhibited larger wear depths than enamel. However, the damage evolution in ENAMIC was similar to that of enamel as the polymer phase was worn preferentially similar to inter-rod enamel, and then the ceramic phase exfoliated from the wear surface akin to enamel rods. The SEM images showed evidence of few cracks within wear tracks of ENAMIC, in comparison to numerous cracks in tooth enamel.SignificanceENAMIC has lower wear resistance than tooth enamel, but it exhibits a wear damage mode similar to tooth enamel.
http://ift.tt/2wJmYQ8
Δεν υπάρχουν σχόλια:
Δημοσίευση σχολίου